How to Install our prepasted wallpaper? Arrow Fat Left Icon Arrow Fat Right Icon Arrow Right Icon Cart Icon Close Circle Icon Expand Arrows Icon Facebook Icon Instagram Icon Pinterest Icon Hamburger Icon Information Icon Down Arrow Icon Mail Icon Mini Cart Icon Person Icon Ruler Icon Search Icon Shirt Icon Triangle Icon Bag Icon Play Video
  • How to Install our prepasted wallpaper?
  • Esther Pichette

How to Install our prepasted wallpaper?

How to Install our prepasted wallpaper?

1. Get ready 

  • Partner in crime ;)
  • Measuring tape
  • Snap off blade cutter
  • Level
  • Water vaporizer or thick paint roller
  • Smoothing brush or plastic smoother
  • Drop cloth or plastic sheet
  • Bucket of clean water
  • Sponge
  • Your wall needs to be smooth, clean and dust free. 
  • Patch or sand any damaged areas of the wall (sharp edges might pierce or tear the paper)
  • Take off any electrical outlet
  • For best results, surface must be a solid surface painted in light colour or primed the same way as if you would normally paint it.
  • If your wall is freshly painted, wait a minimum of 1 week for the paint to dry completely. Else in may lead to air bubbles at the contact of humidity and poor adhesion on the wall.
  • Start by measuring the height of your wall. Installation goes from left to right. Panel #1 being the first on the left.
  • Unroll and cut your first panel from the roll at least 2" at 4" longer that what you need to horizontally. Often, the panels are pre-cut in our Atelier. In this case, the bottom of each panel has a white margin and the top of the panel as no margin. 

2. Start Hanging

  • Place the panel face down on a plastic and generously vaporize water or apply water with a thick paint roller. 
  • Fold the panel glue over glue (fig 1). Wait for 3 to 5 minutes to activate the glue (called booking).
  • Unfold the panel (fig 2) and apply it to the wall vertically levelled and remove the air bubbles and water using a smoothing brush. Keep in mind that some textures have an orientation to respect. 
  • Repeat until done. 
  • Trim excess paper along the ceiling and baseboard with a sharp snap off blade knife. If necessary, re-mist the areas that are dried off. Clean with clean water and a sponge.

* (Fig 3) Only for texture wallpaper: Often, there is a direction for the wallpaper to look realistic. Always keep the up side up. Up is written at the start of each roll. Each panel must be installed butt joint. 

* (Fig 4) Only for photography wallpaper: Follow the number panel and overlap 1/4" inch

3. Enjoy your new wall

  • High five partner in crime, you did it!
  • Make yourself a drink
  • Sit down and enjoy your room metamorphosis
  • Take a picture and go social  #wynil

Cheers !  Our pleasure !! Share your excitement !!!
  • Esther Pichette